Check the Drive Connectionīefore you start using third-party options, you should make sure that your two drives are physically connected correctly. Try cloning again after all the antivirus programmes have been turned off. If you have more than one antivirus programme, turn them all off for a short time. Turn off your antivirus software and try cloning again to fix this. When an antivirus software stops the cloning process, you might see the error “Access denied” along with an error code.

Type “chkdsk : /r” to repair the found error.Īntivirus software might stop a programme from running if it seems to be doing something that could let a virus into the computer.

If you want to check H: drive, then you should type: “chkdsk H: f”.

Press Windows + R key and type “ CMD” in a Run box to bring out a command prompt.

If it has to do with writing data, check the disc where the data is going. If the error has something to do with reading data, check the source disc. The most likely cause of Macrium Reflect error 0 or error 8 is bad sectors, so check the disc for bad sectors first.

Type “ select disk ” to select the destination hard drive.

Type “ list disk” to show all the disks connected to your computer.In the command prompt window, type “ diskpart”.Fix :’Macrium reflect clone failed’ Error Clean destination disk via clean command How to fix the problem with Macrium Reflect clone failed? Do you know why the Macrium Reflect clone didn’t work? Here are a few reasons why the Macrium Reflect clone failed error might happen.